Post by baloo on Feb 24, 2017 16:25:30 GMT
Mine started Ok,
1. But soon found that the filament was being ground up by the feeder, no matter what tension I put on it it keep up doing it.
2. The head is so loose on the sliders it make the head chatter.
3. The temperature of the head keep going up and down eg. 280 to 250 to 180 to 250 etc, even when set to 200c.
4. The ribbon cable at the head keep coming off as it is move back and forth alone the x axis.
5. Now the fan in the power supply is making a grinding sound. so need to be replaced. for the second time.
6. Now both heaters elements have now stopped working.
7 The gap were the mounting plate comes out in the slot in the cover of the X axis, rubs so bad i had the cut 1/16th off the top of the slot.
8 I have replaced the main board 3 times till i found one that worked.
All this in one week.
Would I recommend this printer Hell No.
The only good thing about it is it will make a good looking door stop.
1. But soon found that the filament was being ground up by the feeder, no matter what tension I put on it it keep up doing it.
2. The head is so loose on the sliders it make the head chatter.
3. The temperature of the head keep going up and down eg. 280 to 250 to 180 to 250 etc, even when set to 200c.
4. The ribbon cable at the head keep coming off as it is move back and forth alone the x axis.
5. Now the fan in the power supply is making a grinding sound. so need to be replaced. for the second time.
6. Now both heaters elements have now stopped working.
7 The gap were the mounting plate comes out in the slot in the cover of the X axis, rubs so bad i had the cut 1/16th off the top of the slot.
8 I have replaced the main board 3 times till i found one that worked.
All this in one week.
Would I recommend this printer Hell No.
The only good thing about it is it will make a good looking door stop.